. ATTACHMENTS, OPTIONS AIR SUSPENSION SEAT (F) Adjusting reclining angle Move lever (5) up and move the backrest to the front or rear. Push your back against the backrest when carrying out this adjustment. If your back is not pressing against the backrest, the backrest may suddenly spring forward. Amount of adjustment Forward tilt: 20 degrees (over 20 degrees is free) Rear tilt: 60 degrees NOTICE (G) Adjusting headrest angle Rotate the headrest to the front or rear to set it to the desired angle. Amount of adjustment: 38 degrees (H) Adjusting headrest height Move the headrest up or down to set it to the desired height. Amount of adjustment:
100 mm (3.9 in) (I) Lumbar support Operate switch (6) to give a suitable tension to the lumbar region. When + is pressed: Tension becomes stronger When - is pressed: Tension becomes weaker Adjust the backrest to the desired curve. 6 - 4 If the operator raises his body from the seat or changes the amount of weight applie d to the seat during adj ustment, the air in the suspension may be d ischarged. 2 in) Amount of adjustment: 80 mm (3. After the automatic weight adjustm ent is carried out, the seat height is at the lowe st point in the adjustmen t range. Adjust the seat to the appropriate height. (D) Seat height adjustment n air system, and it can be adjusted steplessly.
The seat height adjustment uses a n air system, and it can be adjusted steplessly. When adjusting the height, pull lev er (3) up fully or push it down fully (when pullin g it up, p ull it until a clic k is felt). When the seat is set at the desire d height, release the lever. If the lever is kept p ulled up, the position w here the seat does not rise any further is the maximum height. When the seat reaches the m aximum height, the sus pension automatically goes down slightly t o secure the amount of movement of the lever. below the adjustment range. To prevent the suspension from re aching the bottom, do not set to the seat height below th e adjustment r ange.
(E) Fore-and-aft adjustment of sea Operate lever (4) up, set the seat cushion in the desired position, then release the Amount of fore-and-aft adjustmen REMARK The seat can be reclined more wh en the seat is pushed to the front. The amount of reclining decreases as the seat is pushed back, so when moving t he seat back, return the seatback to the upright position. If the seat back is reclined too far, the s eat back may hit the rear glass, so use it in a position where it d oes not contact t he glass.