. OPERATION EXPLANATION OF COMPONENTS FUEL CONTROL DIAL WARNING ROOM LAMP SWITCH (Machine equipped with cab) This (3) illuminates the room lamp. OFF position: Lamps are out ON position: Lamps light up 3 - 34 When the machin e is stopped, check that the steering, directional, and gear shift lever is at the N eutral position before turning the fuel control di and the fuel contr personal injury. al to the FULL position.
Ifthe steering, directional, and gear shift lever isat a for ward or reversetravel position ol dial is turned to the FULL position, there i s danger t hat the machine may sudd enly move and cause serious If the steering, dir ectional, and gear shift lever is at a forward o r reverse travel position, check tha t the surrounding area is safe, and then turn fue l control dial slowly to the F ULL position. Dial (1) is used to control the engine speed (a) Low idling pos ition: Turn fully to the left (b) High idling po sition:
Turn fully to the rig REMARK If it is unneces sary to travel at high spee d and the operation has a comparative FULL position improve the fu ly light load, turn the fue l control dial from the slightly towards the low i dling position. This wil el consumption efficiency and reduce t he noise. For leveling an d finishing operations or spreading gr avel, turn the fuel control the low idling p the service life dial also from the FULL p osition slightly towards osition. This will reduce improve HORN SWITCH The horn sounds when the button (2) at the r ear of the blad e contro lever at the right s ide of the operator's seat is pressed.