. OPERATION EXPLANATION OF COMPONENTS BLADE CONTROL LEVER TILTING CONTROL 3 - 41 Thi s lever (6 ) is used to lift, ti lt or angl e the blade. LIFTING CONTROL (A) RAISE: Blade (B) HOLD: Blade s tops and i s held in positio (C) LOWER : Blad e goes dow (D) FLOAT: Blade moves fre ely under external fo REMARK When rel eased from FLOA T positio n, this lever will not r eturn to HOLD po sition, so it must be move d back by hand . Before st arting the engine , check th at the blad e control lever is a t the HO LD e time for the lever to be held at the I n cold w eather , it the f HOLD po sition, so hold th e lever by hand at th e HOLD position or at lea st 1 second. (B) HOLD:
Blade i s stopped and held in this position. (E) LEFT TI (F) RIGHT T ILT Model Tilt amount (mm (in)) Narrow blade Wide blade Wide blade D31EX - 380 (15.0) D31PX 390 (15.4) 445 (17.5) D37EX - 370 (14.6) D37PX 390 (15.4) 445 (17.5)