Komatsu — RECOMMENDED APPLICATIONS

OPERATION MACHINE OPERATIONS AND CONTROLS RECOMMENDED APPLICATIONS In addition to the following, it is possible to further increase the range of applications by using various attachments. BACKHOE WORK A backhoe is suitable for excavating at a position lower than the machine. When the condition of the machine is as shown in the diagram at right, each cylinder's maximum pushing excavation force is obtained when the bucket cylinder and link, arm cylinder and arm are at 90є. When excavating, use this angle effectively to optimize your work efficiency. The range for excavating with the arm is from a 45єangle away from the machine to a 30є angle toward the machine.

There may be some differences depending on the excavation depth, but try to stay within the above range rather than operat- ing the cylinder is the end of its stroke. DITCHING WORK Ditching work can be performed efficiently by attaching a bucket to match the width of the ditch and then setting the tracks parallel to the line of the ditch to be excavated. To excavate a wide ditch, first dig out both sides and then finally remove the center portion. LOADING WORK In places where the swing angle is small, work efficiency can be enhanced by locating the dump truck in a place easily visi- ble to the operator.

Loading is easier and capacity greater if you begin from the front of the dump truck body than if loading is done from the side. 3-83