OPERATION MACHINE OPERATIONS AND CONTROLS BUCKET REPLACEMENT WARNING When the pin is knocked in with a hammer, pieces of metal may fly into your eyes and cause serious injury. When carrying out this operation, always wear goggles, hard hat, gloves, and other protective equip- ment. When the bucket is removed, place it in a stable condition. If the pins are hit with force, the pin may fly and injure people in the surrounding area, so check that the surrounding area is safe. When removing the pin, be extremely careful not to stand behind the bucket or to put your foot or any part of your body behind the bucket from the side.
When removing or installing the pin, be extremely careful not to get your hands caught. Never put your fingers in the pin holes when aligning the holes. Stop the machine on a firm, flat surface. When performing joint work, make clear signals to each other and work carefully for safety's sake. REPLACEMENT 1. Place the bucket in contact with a flat surface. REMARK When removing the pins, place the bucket so that it is in light contact with the ground. If the bucket is lowered strongly to the ground, the resistance will be increased and it will be difficult to remove the pins. 2. Remove the stopper bolts and nuts, then remove pins (A) and (B), and remove the bucket.
NOTICE After removing the pins, make sure that they do not become contaminated with sand or mud and that the seals of bushing on both sides do not become damaged. 3. Align the arm with holes (1) and the link with holes (2), then coat with grease and install pins (A) and (B). AM090960 3-85