Komatsu — HANDLING 4-SYSTEM

OPERATION MACHINE OPERATIONS AND CONTROLS NOTICE If an abnormality occurs in the 4-system, the controller will carry out self diagnosis. Electrical system monitor (1) on the monitor panel will flash, the buzzer will sound, and the error code will be displayed on the depth display. For details of the correct action to carry out, see "OTHER TROUBLE (PAGE 3-131)". Depending on the location of the failure of the 4-sys- tem the controller may not carry out self diagnosis, and it may become impossible to operate the work equipment. If this happens, move the machine to a safe place, and contact your Komatsu distributor for inspection.

Before using the 4-system, always carry out the checks before starting and after starting. In cold areas, carry out thorough warming up before using the machine. If the hydraulic oil temperature is low, the automatic stop may be out of position. Lock stow-away type step (3) at the front right part on the outside of the machine in the stowed position. If the step is left extended, the work equipment will hit step (3) during operations. The 4-system is an automatic control system for the work equipment and a device to prevent interference between the bucket and cab, and the bucket and the front right bodywork. To ensure that this device works properly, always keep to the following points. 3-91