TRANSPORTATION OPERATION SECURING MACHINE After placing the machine on the specified position of the trailer, secure it according to the following procedure. NOTICE Stow the antenna and other parts away. Reassemble the mirrors (for machines equipped with mirrors) so that they are within the width of the machine. To prevent damage to the bucket cylinder during transportation, fit a wooden block at one end of the bucket cylinder to prevent it from touching the floor. Load the machine onto a trailer as follows: 1. Lower the blade. 2. Extend the bucket and arm cylinders fully, then lower the boom slowly. 3. Stop the engine, then remove the key from the starting switch. 4.
Set the lock lever securely to the LOCK position to lock the work equipment control levers. 5. Stop the engine, then remove the key from the starting switch. 6. Close all doors, windows, and covers. Lock the covers, caps, and doors fitted with locks. 7. Place blocks under both ends of the tracks to prevent the machine from moving during transportation, and secure the machine with chains or wire rope of suitable strength. Be particularly careful to secure the machine in position so that it does not slip to the side. When securing the machine, put blocks between the wire rope and the machine to prevent damage to the rope or machine. 3-110