Komatsu — AFTER DAILY WORK COMPLETION

OPERATION COLD WEATHER OPERATION AFTER DAILY WORK COMPLETION WARNING Performing idle-running of the tracks is dangerous, so stay well away from the tracks. To prevent mud, water, or the undercarriage from freezing and making it impossible for the machine to move on the following morning, always observe the following precautions. Remove all the mud and water from the machine body. In particular, wipe the hydraulic cylinder rod clean to prevent damage to the seal caused by mud, dirt, or drops of water on the rod from getting inside the seal. Park the machine on hard, dry ground. If this is impossible, park the machine on wooden boards.

The boards help protect the tracks from being frozen in soil and the machine can start next morning. Open the drain valve and drain any water collected in the fuel system to prevent it from freezing. Fill the fuel tank to capacity. This minimizes moisture condensation in the tank when the temperature drops. After operation in water or mud, remove water from undercarriage as described below to extend undercarriage service life. 1. Swing 90є with engine at low idling and bring the work equipment to the side of the track. 2. Jack up the machine until the track is raised slightly from the ground. Rotate the track under no load. Repeat this procedure on both the left and right sides. 3-117