MAINTENANCE PROCEDURE MAINTENANCE 5. Bleeding air from travel motor (only when oil inside travel motor case has been drained) 1) Run the engine at low idling, remove hose (1) from port C, then when the oil has flowed out, tighten it again. 2) Run the engine at low idling and swing the work equipment 90є to bring it to the side of the track. 3) Jack up the machine until the track is raised slightly from the ground.Rotate the track under no load for 2 minutes. Repeat this procedure on both the left and right sides, and rotate the track equally both forward and in reverse. 4-40