MAINTENANCE MAINTENANCE PROCEDURE Adjusting 1. Remove fan guard (1). 2. Insert a bar between compressor (2) and the bracket (3) to fix compressor (2) in position. When fixing in position, put a piece of wood between the bar and compressor (2) to prevent damage to compressor (2). NOTICE When loosening bolt (4), be careful not to damage piping (6) of the air conditioner. 3. Loosen bolts (4) and (5). 4. Move compressor (2) with the tension adjusting bar so that the deflection of the belt will be 5 - 8 mm (approx. 58.8N(6kgf)). 5. Tighten bolts (4) and (5) to secure compressor (2). Then, take out the tension adjusting bar. 6.
Check each pulley for damage, wear of the V-groove, and wear of the V-belt. In particular, be sure to check that the V-belt is not touching the bottom of the V-groove. 7. Replace belt if it has stretched, leaving no allowance for adjustment, or if there is a cut or crack on V-belt. REMARK When the new V-belt is set, readjust it after operation for an hour. 8. After completion of the adjustment, install fan guard (1). 4-51