Komatsu — REPLACE FUEL FILTER CARTRIDGE

MAINTENANCE PROCEDURE MAINTENANCE REPLACE HYDRAULIC FILTER ELEMENT WARNING The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before cleaning the hydraulic tank strainer. When the oil filler cap is removed, oil may spurt out, so turn the cap slowly to release the internal pressure,then remove it carefully. 1. Remove the cover at the top of the hydraulic tank. 2. Remove the cap from oil filler (F), and release the internal pressure. 3. Loosen 4 bolts, then remove cover (1). When doing this, the cover may fly out under the force of spring (2), so hold the cover down when removing the bolts. 4.

After removing spring (2) and valve (3), take out element (4). 5. Clean the removed parts in diesel oil. 6. Install the new element in the place where old element (4) was installed. 7. Set valve (3) and spring (2) on top of the element. 8. Set cover (1) in position, push it down by hand, and install the cover with the mounting bolts. 9. Install the oil filler cap, then install the cover at the top of the hydraulic tank. 10. To bleed the air, start the engine according to "START- ING ENGINE (PAGE 3-57)" and run the engine at low idling for 10 minutes. 11. Stop the engine. REMARK Wait for at least 5 minutes after stopping the eigine to eliminate bubbles in the oil inside the tank. 12.

Check for oil leakage and wipe off any spilled oil. 4-56