MAINTENANCE MAINTENANCE PROCEDURE CHANGE OIL IN FINAL DRIVE CASE WARNING The oil is at high temperature after the engine is stopped. Wait for the temperature to go down before starting the operation. If there is pressure remaining inside the case, the oil or plug may fly out. Loosen the plug slowly to release the pressure. Container to catch drained oil: Min. 2.5 liters capacity Refill capacity (each): 2.5 liters (0.66 US gal) Hexagon wrench (Width across flats: 8 mm (0.3 in)) 1. Set plug (F) at the top, with plug (F) and plug (P) perpen- dicular to the ground surface. 2. Set a container under plug (P) to catch the oil. 3. Remove plugs (P) and (F) with the hexagon wrench and drain the oil.
REMARK Check the O-rings in the plugs for damage. If necessary, replace with new ones. 4. Tighten plug (P). 5. Add engine oil trough the hole of plug (F). 6. When the oil overflows from the hole of plug (F), install plug (F). CHECK ALL TIGHTENING PARTS OF TURBOCHARGER Contact your Komatsu distributor to have the tightening portions checked. CHECK PLAY OF TURBOCHARGER ROTOR Ask Komatsu distributor to check the play of the turbocharger rotor. CHECK FAN BELT TENSION AND REPLACE FAN BELT Special tools are required for inspection and replacement of the fan belt. Contact your Komatsu distributors for inspection and replacement. 4-59