MAINTENANCE MAINTENANCE PROCEDURE CLEAN HYDRAULIC TANK STRAINER WARNING The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before cleaning the hydraulic tank strainer. When the oil filler cap is removed, oil may spurt out, so turn the cap slowly to release the internal pressure,then remove it carefully. 1. Loosen 4 bolts, then remove cover (1). When doing this, the cover may fly out under the force of spring 2, so push the cover down when removing the bolts. 2. Pull up the top of rod (3), and remove spring (2) and strainer (4). 3.
Remove the dirt stuck to strainer (4), then wash it in clean diesel oil or flushing oil. If strainer (4) is damaged, replace it with a new one. 4. Refit strainer (4) by inserting it into tank projecting part (5). 5. Install cover (1) with bolts. CLEAN, CHECK TURBOCHARGER Contact your Komatsu distributor for cleaning or inspection. CHECK ALTERNATOR, STARTING MOTOR The brush may be worn, or the bearing may have run out of grease, so contact your Komatsu distributor for inspection or repair. If the engine is started frequently, carry out inspection every 1000 hours.
CHECK ENGINE VALVE CLEARANCE, ADJUST As special tool is required for removing and adjusting the parts, you shall request Komatsu distributor for service. 4-61