Mack Trucks — 5-101.bk

5-101.bk Page 43 Friday, March 17, 2006 11:05 AM [213 NB] INLET AND EXHAUST VALVES Inspection Refer to Figure 5-56. Visually inspect valves for cracks, pits or other conditions that may cause improper operation. Check valve seat angle. Also check stem length, diameter and condition. Figure 5-56 — Valve Dimensions (Through September 1996 Production) Valve Identification To permit positive identification, exhaust valve has two stem grooves and inlet valve has one stem groove. The valves are also identified by letters “I” (30-degree inlet), “2” (20-degree inlet), “E” (exhaust) or “Y” (Pyromet exhaust), which are forged in a slight depression on bottom face of valve head.

The Pyromet exhaust valve cannot be used on E7 engines equipped with a Dynatard engine brake. The Pyromet exhaust valve head is 0.020 inch (0.508 mm) thicker than a conventional exhaust valve; therefore, valve-to- piston contact may occur when engine brake is activated. Page 5-43 200 BENCH PROCEDURES