Mack Trucks — 5-101.bk

5-101.bk Page 48 Friday, March 17, 2006 11:05 AM 6. Assemble rocker arm retaining (coil) spring (6) on shaft. 12. Assemble rocker arm retaining (coil) spring (6) on shaft. 7. Lubricate exhaust rocker arm (5) and install on rocker arm shaft. 13. Lubricate exhaust rocker arm (5) and install on shaft. 8. Lubricate valve rocker arm adjusting screw and nut, and install into exhaust rocker arm. 14. Place last (third) rocker arm shaft bracket (4) and shaft on a flat surface. This bracket does not have a threaded hole on top or an oil hole at bottom surface. Align mounting surface and offset of bracket with two brackets already installed. 9.

Place center (second) rocker arm shaft bracket (4) and shaft (12) on a flat surface. This bracket does not have a threaded hole on top or an oil hole at bottom surface. Align mounting surface and offset of bracket with bracket already installed. 15. Check for proper bracket alignment. Press bracket onto shaft. Ensure that mounting surfaces of each bracket are parallel. 10. Press shaft into rocker arm bracket until center lines of mounting holes in brackets are spaced 5.750 inches (146 mm) apart. 16. Lubricate and install outermost inlet rocker arm (3). 17. Install flat spring and retaining snap ring on end of shaft to keep inlet rocker arm in place.

At this point, a used or scrapped cylinder head can be used as a template for proper bracket alignment and to ensure mounting surfaces of each bracket are parallel. 18. At opposite end of shaft, lubricate and install outermost exhaust rocker arm (5). 11. Lubricate inlet rocker arm (3) and install on shaft. Page 5-48 200 BENCH PROCEDURES