5-101.bk Page 5 Friday, March 17, 2006 11:05 AM [213 CC] Camshaft Bushings 2. Refer to the Fits and Limits chart for camshaft bushing measurement specifications. Check the recorded dimensions against the specifications. DESCRIPTION Lubrication oil is pumped into the cylinder block main oil gallery. Oil from the gallery flows to each main bearing bushing bore and then on to the respective camshaft bushing bore, providing lubrication for both the crankshaft and camshaft bushings. Camshaft bushing bores No. 1, 2 and 5 are grooved to supply oil to other components as well. Oil from the No.
1 camshaft bushing bore flows on through a drilled passage to lubricate the front auxiliary driveshaft bushing. Oil from the No. 2 and 5 camshaft bushing bores flows on through vertical drilled passages to lubricate the rocker arm assemblies. Oil from the No. 4 camshaft bushing bore flows through a cast groove in the cylinder block bushing bore to lubricate the fuel injection pump, the rear auxiliary driveshaft bushing, and the air compressor. 3. If bore size exceeds tolerance or if there is any evidence of scratching or scoring, replace the bushings. REMOVAL Refer to Figure 6-5. Use camshaft bushing remover/installer kit J 37713 (use with J 21428-01 kit) for camshaft bushing removal.
Camshaft bushings are identified in sequence from 1 to 7, starting from the front of the engine. INSPECTION 1. Using camshaft bushing remover/installer kit J 21428-01 (2), with the correct pilot adapter (J 37713 kit) and a hammer (3), remove the No. 1 camshaft bushing (4) from the cylinder block (1). During in-chassis overhaul, check the inside diameter of the camshaft bushings. If overhauling out-of-chassis, replace camshaft bushings. 2. Remove the remaining six bushings in sequence. 1. Using a telescope gauge or suitable inside micrometer, measure the ID of each camshaft bushing in the cylinder block. Record the dimensions. Refer to Figure 6-4.
1 2 3 4 200319a Figure 6-5 — Camshaft Bushing Removal Figure 6-4 — Measuring Camshaft Bushing ID Page 6-5 200 ENGINE ASSEMBLY 1. Cylinder block 2. Camshaft bushing remover/installer (J 21428-01 kit) 3. Hammer 4. No. 1 camshaft bushing