5-101.bk Page 8 Friday, March 17, 2006 11:05 AM Refer to Figure 6-8. 1. Position a replacement bushing (2) against the side of the block at the No. 7 (rear) bushing bore. Align the oil hole in the bushing (1) with the oil passage (7) in the block. Refer to Fits and Limits chart for correct bushing ID dimensions. 2. Using a dark-colored felt-tip marker, mark the block and the bushing with a line (5) to facilitate correct alignment at installation. Refer to Figure 6-9. 6. Using an inside micrometer or telescope gauge, measure the ID of the bushing to ensure against an undersize bushing. An undersize bushing may cause the camshaft to seize in the bushing during installation. 3.
Clean the surfaces of the bushing and the bore. Dry both surfaces with compressed air. 4. Using bushing remover/installer J 21428-01 kit (4) and the appropriate pilot adapter J 37713 (3), install the bushing. 1 2 6 3 Figure 6-9 — Camshaft Bushing ID Check 4 5 7. Repeat steps 1 through 6 for all of the remaining bushings in sequence. 6 7 4 6 2 3 200318a Figure 6-8 — Camshaft Bushing Installation 5. Check the surface of the bushing for burrs caused by installation. Page 6-8 200 ENGINE ASSEMBLY 1. Bushing oil hole 2. Bushing 3. Pilot adapter (J 37713) 4. Bushing remover/ installer J 21428-01 kit 5. Alignment mark 6. Mounting hole 7. Block oil passage