5-101.bk Page 11 Friday, March 17, 2006 11:05 AM [212 NC] CYLINDER SLEEVE Description Applying a Silastic bead is now standard assembly procedure whenever cylinder sleeves are installed. The cylinder sleeve works with the piston, piston rings, cylinder head, and cylinder head gasket to seal combustion pressure. It transfers combustion heat to engine coolant and guides piston travel during engine operation. Correct extension of sleeve flange above top deck and uniform cylinder block counterbore are essential for satisfactory sleeve life and head gasket seal. To prevent partial curing and questionable sealing and bonding, apply Silastic just before installing the sleeves. 4.
Apply approximately a 1/8-inch (3.18 mm) bead of RTV silicone (Mack Silastic 342SX32, Dow Corning Silastic RTV732, or General Electric RTV130) around the cylinder block sleeve seat and completely around the cylinder wall. Do not use excessive amounts of RTV. The cylinder sleeves are a wet-dry design, made of centrifugal cast iron. A crevice seal is needed for sealing purposes. Special Tools Required Depth Gauge J 26948 Dial Bore Gauge J 5347-B The cylinder block counterbore ledges and the cylinder sleeve must be kept clean and free of any oil residue to ensure that the Silastic bead seals and bonds properly. Cylinder Hone and Glaze Breaker J 5902-01 Installation Refer to Figure 6-12. 1.
Thoroughly clean and dry the prepared cylinder block (6), counterbore ledge (5) and cylinder sleeves (3). Refer to cylinder block cleaning procedures in this section. 5. Position the cylinder sleeve (3) in the cylinder bore until it contacts the crevice seal (2). 6. Placing the palms of the hands on the upper end of the cylinder sleeve 180 degrees apart, push downward with a quick, even pressure. Using a large plastic-faced hammer, tap the sleeve close to the inside diameter. Tap alternately from one side to the other, gradually working around the entire circumference of the sleeve. 2.
Install the crevice seal (2) into the cylinder sleeve groove with the pointed face toward the cylinder block (6) (outward). Lubricate with ethylene glycol. 3. If the counterbore ledges (5) have been cut, place the shims (4) on the cylinder block counterbore ledges. If more than one shim is necessary, use the fewest number of shims required to achieve the proper cylinder sleeve flange height. Always place the thickest shim on the bottom. The crevice seal groove (1) must be clean and free of any oil residue. Under no circumstances should oil contaminate the crevice seal groove or crevice seal. Damage to the seal will result. Page 6-11 200 ENGINE ASSEMBLY