Mack Trucks — 5-101.bk

5-101.bk Page 14 Friday, March 17, 2006 11:05 AM [219 RV] PISTON COOLING SPRAY NOZZLE Special Tools Required Piston Cooling Nozzle Spray Position Set J 37721-A (for 1989/1990 production) Description Two-Piece Piston Cooling Nozzle Aimer J 39045 (for 1991 and later production) Refer to Figure 6-14. The piston cooling system consists of an oil pump, oil passages drilled in the cylinder block, and an oil spray-nozzle assembly for each piston. The piston cooling nozzles are attached to the main oil gallery. Oil is discharged through the nozzles and into the underside of each piston. This spray provides additional piston cooling. The oil returns, by gravity, to the crankcase oil pan.

Inside the crankcase at each cylinder is a drilled oil passage from the main oil gallery and one threaded hole for the retaining screw. Installation Refer to Figure 6-15. 1. Using a liberal amount of lubricant, install elastomer sleeve (7) on locator tube (6). 2. Install a retaining screw (4) in the spray nozzle bracket (3). 3. Position spray nozzle locator tube (6) in cylinder block oil passage (2) and torque retaining screw to 15 lb-ft (20 N m) using torque wrench J 24406 or equivalent. Beginning with 1991 E7 engine production, piston cooling nozzle hardware and nozzle spray positioning tool changes have been made. The two-piece piston design uses two types of cooling.

A unique splash and forced piston cooling system first appeared on the 1991 E7 engine. Precise targeting of the piston cooling spray provides adequate cooling to the piston crown and fills the four oil reservoirs located in the top of the piston skirt. 2 1 3 4 The piston cooling nozzle bracket is thicker on the piston cooling nozzles beginning on 1991 E7 production engines. Also, “310” is etched on the pre-1991 piston cooling nozzle, and “316” began in 1991 E7 production. These parts are not interchangeable with 1989/1990 production.

5 6 7 200280a Figure 6-15 — Spray Nozzle Installation 1989/1990 E7 PRODUCTION BEGINNING IN 1991, E7 PRODUCTION 200278a Figure 6-14 — Spray Nozzle Comparison Page 6-14 200 ENGINE ASSEMBLY 1. Threaded hole 2. Oil passage 3. Spray nozzle bracket 4. Retaining screw 5. Cylinder block 6. Locator tube 7. Elastomer sleeve