Mack Trucks — 5-101.bk

5-101.bk Page 24 Friday, March 17, 2006 11:05 AM Installation Refer to Figure 6-24. MACK E7 6-cylinder engines use a special type of connecting rod bearing. Each bearing half has a different thickness. The upper (rod) bearing half is thicker than the lower (cap) half. This design increases the load-carrying capacity of the upper bearing and provides longer bearing life. 1. Rotate crankshaft so that the journals for the No. 1 and No. 6 cylinders are at bottom dead center. 2. Place piston, marked No. 1, on a clean, flat surface. Rest the piston and rod assembly on the piston crown with the rod upward. 3. Apply a light coat of clean engine oil to piston and rings. 4.

Apply a light coat of clean engine oil to inside surface of the piston ring compressor J 23442 or PT7070-A. The hole in the upper connecting rod bearing must be aligned with the oil passage in the connecting rod. Otherwise, damage to the bearing, rod and crankshaft journal will result. 5. Install ring compression tool by slipping it over the rod and down over the piston skirt with tapered end downward. 8. Position an upper (rod) bearing into the connecting rod. Align tab in the bearing with notch in the rod. Be sure that the hole in the bearing aligns with the oil passage in the rod. 9. Apply a light coat of clean engine oil to bearing surface. 10.

Apply a light coat of clean engine oil to inside surface of the No. 1 cylinder sleeve. 11. With the ring compression tool in place, position piston and rod assembly into the No. 1 cylinder. The arrow and word FRONT on both the piston crown and the connecting rod must be facing the front of the engine. Apply downward pressure to the ring compression tool, keeping it in contact with the cylinder sleeve, until the top ring has passed into the cylinder sleeve. Otherwise, damage to the rings may result. Figure 6-24 — Piston and Connecting Rod Installation 12.

Make sure connecting rod aligns with journal and, using a hammer handle, carefully push piston into cylinder until piston crown is below the surface of the sleeve. 6. Carefully slide tool downward while guiding rings into the ring grooves. 7. Continue sliding tool downward until it contacts the surface on which the piston crown is resting. Page 6-24 200 ENGINE ASSEMBLY