5-101.bk Page 42 Friday, March 17, 2006 11:05 AM Refer to Figure 6-50. [219 MU] OIL PUMP 3. Install thrust washer (4) and secure it in position with the patch-lock capscrews (3) and hardened washers. Description The oil pump is a gear-type pump. As the pump rotates, a vacuum forms on the inlet side, drawing oil from the crankcase through the oil pump inlet pipe, and into the pump gear compartment. Oil then passes through the regulating valve. Regulated pressure then forces oil through the discharge port into a drilled passage in the cylinder block, which leads to the oil filter and cooler. The oil is then distributed to all main parts of the engine.
If the oil filter is excessively contaminated, the filter bypass valve will open, allowing the unfiltered, contaminated oil to continue through the engine. 4. Torque the thrust washer retaining patch- lock capscrews to 15 lb-ft (20 N m) using torque wrench J 24406 or equivalent. 5. Install auxiliary driveshaft gear (2) on shaft splines (5). The auxiliary driveshaft and nut threads must be clean and dry before assembly. Clean the threads thoroughly with Brakleen or electrical contact cleaner. Apply Loctite 271 or 277 to the threads and install the nut.
Oil fed to the main bearings also travels through the connecting rods into the piston wrist pins to lubricate the pistons and cylinder sleeve surfaces. Oil jets below the pistons, also fed by the oil pump, spray the bottom of the pistons with the pressurized oil to assist in removing some of the heat from the pistons produced by combustion. Oil is then returned, by gravity, to the crankcase. 6. Install auxiliary driveshaft nut (1) and torque to 300 lb-ft (407 N m) using torque wrench J 23775-01 or equivalent. Do not mix standard-ratio oil pumps with fast-ratio pumps. Damage to the engine will result. Current fast-ratio oil pumps: Part No. 315GC459AM, with rear sump Drive gear, No.
683GB284 (12 teeth) Figure 6-50 — Auxiliary Driveshaft Gear Installation Former standard-ratio oil pumps: Part No. 315GC460M, with rear sump Drive gear, part No. 683GB287 (13 teeth) Make sure the oil pump is in satisfactory condition as described in the BENCH PROCEDURES section of this manual. Page 6-42 200 ENGINE ASSEMBLY 1. Nut 2. Auxiliary driveshaft gear 3. Capscrew 4. Thrust washer 5. Shaft splines