5-101.bk Page 48 Friday, March 17, 2006 11:05 AM With the new isolating oil pan gasket arrangement, the mounting holes tapped into the cylinder block, timing gear cover, and flywheel housing are now 8 mm rather than 10 mm. The illustration below, Figure 6-55, shows the newer production arrangement. The fiber oil pan gasket can be used on engines with either 8-mm or 10-mm tapped mounting holes. The isolating oil pan gasket may only be used on cylinder blocks with 8-mm tapped holes.
A A B A A A B B ASSEMBLY A (BOLT) B B A SHOULDER BOLT – 421GC289M (20 BOLTS) OIL PAN ISOLATOR – 41GC212 (20 ISOLATORS) ASSEMBLY B (STUD) SHOULDER STUD – 616GC239M (10 STUDS) STUD NUT – 189AM1 (10 NUTS) OIL PAN ISOLATOR – 41GC212 (10 ISOLATORS) B B B B B A B A A B A A B A 200575a Figure 6-55 — Oil Pan Stud Identification Page 6-48 200 ENGINE ASSEMBLY