Komatsu — Fitting the attachment

3.4. Transport Operation 8. Insert the fastening screws (5) for the retaining bolts on both lift arms (6) and pull tight (one screw on each side). Torque: see "Torque" chapter 6 5 9. Lubricate the bearings of the lift arms at the grease nipples (10) in the retaining bolts. 10 10. Raise the tilt arm (2) and align so that the retaining bolts (4) can be inserted. Weight of the tilt arm = 100 kg. 2 4 11. Grease the dust rings (9) for the tilt arm (2). 12. Place the dust rings (9) on the tilt arm (2). 13. Check the play between the tilt arm and the attachment holder. The play must not exceed a maximum of 1 mm. Use washers as for the connection between lift arms / attachment holder. 14.

Grease the retaining bolt (4) and insert. 9 NOTE 1 The bearing for the tilt arm (2) is lubricated by the central lubrication system. Use a retaining bolt without lubrication hole. 15. Insert the fastening screw (1) for the retaining bolt (4) of the tilt arm (2) and pull tight. Torque: see "Torque" chapter. 4 2 3-86