4.1. When the machine runs out of fuel Troubleshooting 4.1. When the machine runs out of fuel Fire risk! Spilled fuel may ignite! Remove carefully any spilled fuel. Proceed as follows if the fuel tank is empty: 1 1. Fill up with fuel. For more information see: "Refuelling with a fuel dispenser" on page 5-41 or "Refuelling from drum" on page 5-41 2. Open the maintenance flap on the right side. 3. Loosen the vent screw (1). 4. Loosen the feed pump knob (2) and move the pump up and down until bubble-free fuel comes out of the vent screw. 5. Retighten the vent screw. Then press down and retighten the knob of the feed pump. Caution during turning the engine. It may start up after a few turns!
2 6. Set the key in the start switch to START position and start up the engine for 15-20 seconds. On no account activate the starter for longer than 20 seconds. Always wait for two min- utes before restarting. 4-2 WARNING WARNING CAUTION CAUTION