5.8. Service procedure Maintenance 11. Replace the corrosion resistor cartridge and open valves. For details about replacing the corrosion resistor, see "5.8.8. Every 1000 service hours" on page 5-61. 12. Add cooling water until it overflows from the water filler. 13. To remove the air in the cooling water, run for five minutes at low idling, then for another five minutes at high idling with the radiator cap (2) removed. 14. Unscrew the expansion tank’s (6) drain plug (5), allow the coolant to drain off and clean the inside of the expansion tank. Screw the drain plug back in and tighten. Top up with coolant until the coolant level is located between the FULL and LOW markings. 15.
Stop the engine, wait for about three minutes, add cooling water up close to the radiator water filler port, then retighten the cap. 6 5 5-28