Introduction 1.7. CE-conforming equipment 1.7.3. Manufacturer-supplied CE-conforming equipment, according to document 419-93-H1160 The responsibility for observing valid regulations in the case of wheel loaders with "interchangeable equipment" (e.g. bucket or fork-lift) which was not supplied from works lies with the customer which was subsequently fitted to the machine. The directives for CE conformity are deemed to have been ful- filled when the manufacturer of the equipment confirms fulfilment of the form 419-93-H1160. The certification must be sent to the customer and the wheel loader manufacturer.
The CE conformity declaration for a specific wheel loader is only legally valid once this has taken place. The dimension Sh (smallest tyre radius) must be added to the dimension D2 . The figure G (in kg) represents the maximum load (equipment and operating load) which may act upon this point. G A1 A2 Sh GK100395b 1-21 D2 Sh