5.8. Service procedure Maintenance 5.8.9. Every 2000 service hours It is recommended to include all maintenance operations described in the sections Every 50, Every 100, Every 250, Every 500 and Every 1000 Service Hours while performing the following tasks. Changing the oil in the hydraulic tank, replacing the hydraulic filter inserts Immediately after machine operation, the oil is hot. There- fore, wait for the oil to cool down before changing it. When removing the oil filler cap, turn it slowly to release the inter- nal pressure, then remove it carefully. Keep the following items at hand for the oil change: Collecting container with sufficient capacity (min. 180 l).
Oil quantity required for refilling according to the table "5.4.2. Lubricants, fuels and filling capacities" on page 5-14. 1. Lower the bucket horizontally to the ground and apply the parking brake, then stop the engine. 2. Remove the cover screws above the oil filler neck (F) and the take off the cover. 3. Remove the cap from oil filler port (F). 4. Set a collecting container under drain plug (1). F 5. Remove drain plug (1). 6. Open drain valve (2) gradually to drain the oil. 7. After draining the oil, close drain valve (2), then tighten drain plug (1). Tightening torque: 1 Drain plug (1) 60 - 78 Nm Drain plug (2) 50 - 78 Nm 1 5-66 WARNING WARNING