2.2. Safety precautions during operation Safety Driving When driving, set the bucket to the transport position. When driving on uneven ground, drive slowly and avoid sud- den steering movements. The emergency steering system only functions if the machine is being pulled or the engine is running. Driving on slopes 270 mm GK100204b Keep sufficient distance to ridges and steep slopes. There is danger of the machine tipping over or sliding down on steep slopes, embankments, or hill flanks. The limiting values are defined in chapter "6.4. Limit values for slopes" on page 6-3.
To keep the centre of gravity as low as possible when driving on slopes, embankments, and hill flanks, you must set the bucket to a position just above the ground. In an emergency, quickly lower the bucket to the ground to stabilise the machine. Do not turn on a slope or drive across a slope. Turn or cross the section only level ground. AE060800 When driving on slopes, avoid driving on grass, fallen leaves, or steel plates. Driving sideways on these surfaces may result in the machine sliding. Drive very slowly and carefully. When driving down a slope, use the braking power of the engine and drive slowly.
If the engine stops while you are driving on a slope, immedi- ately apply the service brake to stop the machine. Then apply the parking brake. Lower the work unit. When driving on a hill with a load, drive AE060810 uphill: in forward direction downhill: in reverse direction 2-14