2.2. Safety precautions during operation Safety Brakes Use the brake pedal only for braking, do not use the brake pedal as a foot rest. Do not step repeatedly onto the brake pedal, unless it is absolutely necessary. When driving downhill, use the engine as a brake and use the brake pedal, if necessary. Working on loose soil Do not drive the machine too close to edges of hills, over- hangs, and deep ditches. If the soil starts to sag at these locations, the machine may tip over, fall down, or roll over, thus injuring you severely. Take into account that the soil is wet and soft after heavy rain- fall, or very loose after blasting.
Parking the machine If possible, park the machine on an even surface. If you have to park the machine on a slope, you must park the machine with the work unit pointing down the slope. Lower the work unit until it firmly touches the ground (1), or let the cutting edge of the bucket sink deeply into the soil. Block the wheels with wheel chocks (2) to ensure that the machine cannot roll away. Adhere to all regulations on parking vehicles and securing building sites. GK100667 Before you leave the machine, completely lower the work unit onto the ground. Secure the control lever of the work hydrau- lic system against accidental operation. Switch off the motor.
Lock all points that can be locked and store the key in a safe place. 2-18