Komatsu — Securing the working attachment

Safety 2.3. Precautions for maintenance Securing the working attachment 1 Risk of injury! The attachment may fall suddenly when in raised position! For safety reasons, a raised attachment must be secured against dropping before you pass or stand under it. The working attachment must be propped up against falling down whenever any work is carried out underneath the working attach- ment when raised. For this purpose use a support (1) which is to be placed below the boom. AE418280 The following procedural description must be adhered to where supports are used. A 1. Park the machine on level, solid ground. 2. Engage the parking brake by pressing the toggle switch (2) on the steering column.

B Pos. A ON The parking brake is applied. The warning light for the parking brake goes on. Pos. B OFF The parking brake is released. 2 GK100420 3 3. Place wheel chocks in front of the wheels to prevent the machine from inadvertently rolling away. 4. Raise the boom sufficiently far to enable the support (1) to be placed underneath it. 5. Switch the engine off. 6. With the engine switched off lower the boom slowly until it rests securely on the support. 7. Use the safety lever to secure the control lever for the work- ing hydraulics (3). 4 8. Move the driving direction lever (4) to the neutral position (N). 1 N 2 AE061330 2-23 DANGER DANGER