3.2. Description of the individual elements Operation Control and measurement indicators (A, C and D) These parts comprise the meters (speedometer, fuel gauge, engine water temperature gauge, torque converter oil tempera- ture gauge, service meter, transmission shift indicator) and the pilot lamps (turn signal indicator, head lamp, high beam, preheat- ing, front working lamp, rear working lamp, transmission cut-off, parking brake). Warning light and indicator for emergency-steering (F) This part comprises the warning light and the indicator for the emergency steering system. For details see section "5. Maintenance" on page 5-1 and follow- ing and chapter "5.8.3.
Checks before starting" on page 5-40. Alarm indicators (B, E) These parts comprise the central check lamp (CHECK), the cen- tral warning lamp (CAUTION), and warning pilot lamps (engine water level, engine oil level, brake oil pressure, engine oil pres- sure, battery charge, and air cleaner clogging). Checking the control system After switching off the engine, wait at least 30 before starting to check the control system. Before starting the engine, set the starting switch to operating position ’ON’. Control if all instruments and control/warning indicators light up for approx. 3 seconds, the alarm buzzer produces an audible signal (approx.
1 second), the speedometer displays the number ’88’, the transmission shift indicator displays the number ’8’, finally two beeps indicate that all control checks are termi- nated. If you detect a malfunction, arrange an inspection with the rele- vant dealer. NOTE If the start switch is turned to operating position ’ON’ with either the direction lever not being in the neutral position, the central warning lamp (CAUTION) and the alarm buzzer will issue a signal. In this case, reset the lever or the switch to the neutral position. The warning lamp goes out and the audible signal is ended. 3-6