Komatsu — Adjusting the length of the directional lever

3.2. Description of the individual elements Operation 1. Gear lever This lever controls the travel speed of the machine.The machine is fitted with an automatic transmission with 4 FORWARD and 4 REVERSE GEARS. Push the gear lever into the position for the required speed range. 1 1st and 2nd gears are used for working. 2 A 3rd and 4th gears are used for travel. 3 4 If the gear lever stop (A) is applied (see item "3. Gear lever stop" on page 3-29), it is not possible to shift into 3rd or 4th gear. Deac- tivate the gear lever stop before changing gear.

GK100245 Position 1 1st gear Position 2 2nd gear Position 3 3rd gear Position 4 4th gear Adjusting the length of the gear lever The length of the gear lever (1) can be adjusted to three different lengths (positions A, B and C). To adjust length, remove the screw (2) underneath the lever grip (3) and push the grip to the required position and then fasten in position again using the screw (the lever is set to position B at works). A B C 3 1 2 AE061310 2. Directional lever This lever is used for changing the travel direction. The engine can only be started if the directional lever is set to the neutral N position.

1 2 Position 1 Forward drive N Position N Neutral Position 2 Reverse drive AE061330 Adjusting the length of the directional lever A B C The length of the lever (1) can be adjusted to three different lengths (positions A, B and C). To adjust length, remove the screw (2) underneath the lever grip (3) and push the grip to the required position and then fasten in position again using the screw (the lever is set to position B at works). 3 1 2 AE061310 3-28