GROUP 3 MONITORING SYSTEM GROUP 3 MONITORING SYSTEM 1. 1. CLUSTER CLUSTER 1) 1) STRUCTURE STRUCTURE The cluster consists of gauges, lamps and LCD as shown below, to warn the operator in case of abnormal machine operation or conditions for the appropriate operation and inspection. · Gauges : Indicate operating status of the machine. · Warning lamps : Indicate abnormality of the machine. · Pilot lamps : Indicate operating status of the machine. · LCD : Indicates selected the driving speed and direction. The cluster installed on this machine does not entirely guarantee the condition of the The cluster installed on this machine does not entirely guarantee the condition of the machine.
Daily inspection should be performed according to chapter 6, M machine. Daily inspection should be performed according to chapter 6, M AINTENANCE AINTENANCE in operator's manual. in operator's manual. When the cluster provides a warning immediately check the problem, and perform the When the cluster provides a warning immediately check the problem, and perform the required action. required action.
Emergency warning lamp Left turning pilot lamp Right turning pilot lamp Speedometer T/M oil temperature gauge Hyd oil temp gauge Engine coolant temperature gauge Fuel gauge Lamps (See page 7-23) Battery volt meter Lamps (See page 7-23) LCD (See page 7-29) 7809S7EL30 GAUGE GAUGE 2) 2) Speedometer Speedometer (1) (1) Unit ① The speedometer displays the speed of machine in mph and km/h. The unit ( The unit ( km/h km/h or or mph mph ) can be set by the display set up menu ) can be set by the display set up menu of the monitor and selected unit is displayed. of the monitor and selected unit is displayed. Refer to page 7-41. Refer to page 7-41. 75793CD03 7-21