Komatsu — WHEN MACHINE RUNS OUT OF FUEL

. OPERATION TROUBLESHOOTING TROUBLESHOOTING PROCEDURE FOR BLEEDING AIR CAUTION the inside of the filter with and check that air bubbles 3 - 153 WHEN MACHINE RUNS OUT O In case t hat the machine has run out o f fuel, start the engine again only after refilling fue l, filling the water sep arator and fuel filter cartridge with clean fuel Always w atch the fuel level and be ca If th e engine has stopped because of l ack of fuel, it is necessary to use t he priming pum p to bleed the air completely from the B e careful when unscrewing the air bleedin g plug on the fuel filter head. Oil may spurt out due to t he residual pressure insi de the tank. If clean f uel is not available, go on to 1. i 2.

3. 4. 1. Remove fuel filter cartridge (1), fil clean fuel, taking care not to let di t again. Add f uel from small hole (A) (dirty add fuel from hole (B) (clean side) Loosen air bleed plug (2) at the fu 3. Blee d air with priming pump (3) com e out of air bleeding plug (2), 4. Tighten air bleed plug (2). Tightening torque: 7.8 to 9.8 Nm ( 5. Turn the key in the starting switch to the START position and start the engine. Whe n doing this, do not crank the starting motor continuously for more than 20 seco nds. If the engine do es not start, wait for at least 2 minutes, t hen try again. Perform this operation a maximum 6. I f the engine does not start, repea