Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE machine. REMARK 4 - 29 4. Check that the pilo t lamp inside the switch and the cooling fan reverse rotation pi lot lamp on the machine mon itor are lighted up. At the sam e time, "COOLING FAN REVERSE" is displayed on the c haracter display, and the fan is set to reverse rotation. Turn the key in th 5. e starting switch to the STAR start the engine. The cooling fan wi 6. Run the engine at Select the time for running the engine at high id le as follows according to the conditio n of clogg Normal clogging: Excessive cloggin 7. After completing t he cleaning, run the engine a t low idle for approx. 10 8.

Turn the starting s witch to the OFF position an d stop the engine. 9. When the fan rotat ion stops, loosen wing bolts (2 ), use hook (3) to slide cleaning c overs (4), and open the left an d right covers. 10. Steam or water can b e used instead of compresse 11. After blowing dirt o ut, install cleaning cover (4). 12. Run the engine at 13. Turn the key in the starting switch to the OFF p osition and stop the 14. Turn starting switc h key to the ON position. 15. Set cooling fan rev erse rotation switch (1) to pos ition (b) (OFF) to cancel the reve 16. Check the rubber hose. Replace with a new on e if the hose is found to have crac ks or to be hardened by agin Also, check hose