. MAINTENANCE SERVICE PROCEDURE TURN, REPLACE BOLT-ON CUTTING EDGE WARNING lock lever position. 4 - 32 It is dangerous if the work equipment moves by m istake during the turning or replacement op Set the work equipme nt in a stable condition, st work equipmen r secure ly to the LOCK Turn or replace the cutting edge before the wear reache s the edge of the 1. Raise the bucke the bucket to pr Raise the buck horizontal. 2. Remove nuts a 3. Clean the moun 4. Turn cutting ed the edge, instal right edge to lef If both sides of part. If the wear ex mounting surfa 5. Tighten nuts an Tightening torq 6. Tighten the mo 1.
Raise the bucke t to a suitable height, the n put blocks (A) under event the bucket from co ming down. ce before installing the cu tting edge. 5. Tighten nuts an d bolts (1) uniformly so t hat there is no gap between t he bucket and cutting edg ue for mounting bolt: 745 ± 108 Nm ( 76 ± 11 kgm, 549.7 ± 79.6 l 6. Tighten the mo unting bolts again after o perating for several hours 2. Remove nuts a nd bolts (1), then remove cutting edg 3. Clean the moun ting surface of cutting ed ge (2). 4. Turn cutting ed ge (2) and install it to the bucket. Wh en turning l it to the opposite side (l eft edge to r ight side, the cutting edge are wor n, replace w