. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE WARNING stopped, and may cause burns. Wait for the 4 - 52 EVERY 500 HOURS SER Maintenance for every 50, 100 and 250 hours service should be carried out at the same ti temperature to go down before When removing the oil filler cap, turn it slowly to release the internal p ressure Refill capacity: 38 liters (10.0 1. Open the engine side cove r on the right side of the chassis. he oil under drain plug (P). drain the oil. nd if there are excessive meta al, please contact your Komatsu 2. 3. Open oil filler (F). Place a container to catch t 4. Loosen drain plug (P), and 5.
Check the drained oil, a particles or foreign materi distributor. Install drain plug (P). 6. 7. Using a filter wrench, turn fi lter cartridge (1) counterclockwise on remove it. 8. Clean the filter holder, fill th e new filter cartridge with oil, then coat the seal and thread of the filter cartridge with oil (or coa all. seal surface into contact with the urther 3/4 to 1 turns. tridge, add oil through oil filler (F thinly with grease) and inst 9. When installing, bring the filter holder, then tighten a f 10. After replacing the filter car until the oil level is between the H and L marks on the dipstick (G). 11.
Run the engine at idle for sh ort time, then stop the engine, and check that the oil is between the H and L marks on the dipstick For details, see "CHECK O ADD OIL (PAGE 3-95)". IL LEVEL IN ENGINE OIL PAN