. MAINTENANCE SERVICE PROCEDURE CHECKING FUNCTION OF ACCUMULATOR For details of handling the accumulator, see Section "ACCUMULATOR (PAGE 2-35)". equipment to the ground. 1. Apply the parking brake. 2. Raise the work equipment to the maximum height, then operate the lift arm control lever to HOLD position (b). 3. Stop the engine. 4. Leave the work equipment lock lever in the FREE position. 5. Check that the area around the machine is safe, then operate the lift arm control lever to FLOAT position (d) and lower the work equipment to a point 1m above the ground. 6.
When the lift arm comes to the 1m position, return the lift arm control lever to LOWER position (c), and lower the work equipment slowly to the ground. REMARK Carry out the check within 2 minutes after stopping the engine. If the machine is left with the engine stopped, the accumulator pressure will drop and it will be impossible to check the cause of the problem. no grease on the bearing, so contact your Komatsu distributor for inspection or CHECK INJECTOR NOZZLE (Only areas with EPA exhaust gas restrictions) Ask your Komatsu distributor to carry out this work.
4 - 63 PPC ACCUMULATOR If the engine stops with the work equipment raised, and it is impossible to start the engine a gain, it is possible as an emergency measure to actuate If the work equipment stops whil e it is moving, the gas pressure in the accumulator has pr Please contact your Komatsu di stributor to have the accumulator inspected. 4000 hours or every 2 years. Replace the accumulator every CHECK ALTERNATOR, STA The brush may be worn or have repair.
If the engine is started frequentl CHECK ENGINE VALVE CLE ARANCE, ADJUST As special tool is required for re moving and adjusting the parts, request your Komatsu dis CLEAN AND CHECK TURBO CHARGER If there is carbon or oil sludge stu ck to the blower impeller, it will lower the performance of th e turbocharger or cause it to break, so ask your Komatsu distributor to carry out the cleaning.