EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 8.1 DESCRIPTION AND OPERATION OF AIR INTAKE MANIFOLD AND RELATED PARTS On diesel engines, the intake charge air is routed to an intake manifold that is bolted to the cylinder head with thirteen bolts. Air is then routed through the manifold and into the cylinders. The mating surfaces of the manifold and the cylinder head are machined. The intake manifold is sealed to the cylinder head with six rubber and steel gaskets. If the manifold is removed, new gaskets must be installed to maintain seal under higher boost pressure. An intake manifold air temperature sensor is installed to the intake manifold.
The Exhaust Gas Recirculation (EGR) mixer, intake throttle valve and adaptor installed to the air inlet of the intake manifold. CAC ducting is installed on the intake throttle valve adaptor. For EPA07 engines, there is a pressure combination sensor in the cold boost pipe, and a temperature sensor in the intake throttle adaptor. For EPA10 engines, these sensors are combined. The combination sensor is located in the Cold Boost Pipe, and is used to measure air pressure and air temperature. All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 8-3