Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE PERSONAL INJURY To avoid injury when removing or installing a heavy engine component, ensure the component is properly supported and securely attached to an adequate lifting device to prevent the component from falling. 10. For EPA10 DD13 engines, connect the air line supply (1) to the EPV (2). 11. Connect the turbocharger speed sensor connector to the engine wiring harness. 12. Reconnect the flange to the exhaust manifold. 13. Install the coolant inlet and outlet lines to the doser injector housing. Torque to 15 N·m (11 lb·ft). 14. Install the fuel line to the doser injection valve. Torque to 23-25 N·m (17-18 lb·ft). 15.

Install the turbocharger heat shields. 16. Install the two bolts to the turbocharger support bracket and turbocharger. Torque the bolts to 25 N·m (18 lb·ft). 17. Install the compressor elbow and the Charge Air Compressor (CAC) plumbing. Torque the clamps to 6 N·m (4 lb·ft). 18. Connect the compressor inlet hose. All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 9-11