9.5 EGR COOLER CLEANING PROCEDURE TO REMOVE EXCESS FUEL FROM COOLER AFTER DD13 TURBOCHARGER FAILURE Check as follows: NOTICE: This cleaning procedure must be followed after replacing a DD13 turbocharger so that any failure will not cause excessive fuel, oil, or coolant to enter the exhaust system. Failure to perform this procedure could cause severe engine damage. 1. Shut off the engine, apply the parking brake, chock the wheels, and perform any other applicable safety steps. 2. Remove the clamps (2) and the EGR hot pipe (3) from the EGR cooler and inspect for any signs of liquid or moisture. The hot pipe and EGR cooler inlet should have a black dry soot residue inside. Refer to section .
[a] If liquid or moisture is present in the pipe, go to the next step. [b] If there is no sign of liquid or moisture in the pipe, install the EGR cooler hot pipe. No further action is required. Refer to section . All information subject to change without notice. 9-14 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION