Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

11.2 REMOVAL OF DD15 TURBOCHARGER 3. Remove APT air feed line from the compressor housing. 4. Remove the turbocharger oil supply and drain line from the center housing. 5. Remove and discard O-ring from the cylinder block and gasket from center section. 6. Remove large marmon clamp connecting APT to the interstage duct. 7. Loosen the bolts attaching the turbocharger support bracket to the cylinder block. 8. Remove four bolts attaching the turbocharger to the exhaust manifold center section. 9. Remove the two bolts from turbocharger bracket to turbine housing.

PERSONAL INJURY To avoid injury when removing or installing a heavy engine component, ensure the component is properly supported and securely attached to an adequate lifting device to prevent the component from falling. 10. Attach a chain hoist and a suitable lifting sling to the turbocharger assembly. NOTICE: Turbocharger must be supported when removing the mounting bolts to avoid damage to the turbocharger. 11. Lift the turbocharger assembly away from the engine and place it on a bench. 12. Cover turbocharger to avoid any foreign material from entering oil, air, or exhaust passages.

PERSONAL INJURY To avoid injury from improper use of chemicals, follow the chemical manufacturer’s usage, handling, and disposal instructions. Observe all manufacturer’s cautions. 13. Clean the exterior of the turbocharger with a non-caustic cleaning solvent. All information subject to change without notice. 11-6 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION