EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 13.4 INSTALLATION OF THE AXIAL POWER TURBINE GEAR BOX Install as follows: NOTICE: Ensure the gear box gear and idler gear located in the gear case housing are meshed. Failure to mesh gears correctly will cause damage. 1. Install the gear box to cylinder block; ensuring the gears are meshed together when installed. NOTICE: Ensure the correct bolt length is used when the gear box is installed. If an incorrect bolt length (too long) is used, the cup plugs installed in the cylinder block can be pushed out into the gear train causing severe damage to the gear train.
The correct bolt length for the bolt installed in the upper location near the cylinder block is 35 mm (1.37 in). The correct length for the bolt located in the lower position of the gear box is 120 mm (4.72 in). 2. Install four bolts into gear box and cylinder block and hand tighten. 3. Torque the four bolts to 55-60 N·m (41-44 ft·lb). 4. Install oil line to gear box and engine block. Torque to 35 N·m (26 lb·ft). All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 13-7