Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 14.1 DESCRIPTION AND OPERATION OF CYLINDER HEAD AND RELATED PARTS This section explains the description(s) and operation(s) of the following systems within the cylinder head: Cylinder Head Valve Springs and related components Intake and Exhaust Valves 14.1.1 Cylinder Head The cylinder head has been designed with a compacted graphic iron material. There are two intake and two exhaust valves per cylinder. To ensure the correct bolts are used when installing the cylinder head, the bolt thread size 16 is stamped on the head of the bolt. All bolts must be tightened in the correct sequence.

The valve train assembly needs to be removed in order to access the cylinder head bolts. The cylinder head has a split coolant jacket; the coolant flows around the cylinder to the inlet side of the head and then to the exhaust side. The coolant flows in the lower level of the cylinder head around the injectors and the valve seat rings. The coolant then flows around in the upper level of the cylinder head and cools the valve guides. The advantage of this design is a very even and highly effective cooling system. 1. Oil Return Openings or Oil Return Holes From Cylinder Head to Cylinder Block 2.

Oil Transfer Holes from Cylinder Block to Cylinder Head Figure 14-1 Oil Hole Location on Fire Deck of Cylinder Head All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 14-3