Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 1. Holes for Installing the Intake Manifold 2. Inlet Ducts Figure 14-4 Cylinder Head Inlet Duct Location 14.1.2 Intake and Exhaust Valves There are four valves per cylinder; two intake valves and two exhaust valves. Valves are made of heat-treated alloys, with precision-ground heads and stems. Stem ends are hardened to minimize wear in contact with the valve rocker buttons. All valves are retained by valve spring caps and two-piece tapered valve locks. Valve stem oil seals are installed on both intake and exhaust valves to provide controlled valve stem lubrication while limiting oil consumption. All information subject to change without notice.

DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 14-5