Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

14.8 REMOVAL OF VALVE SPRING (CYLINDER HEAD INSTALLED) 14.8 REMOVAL OF VALVE SPRING (CYLINDER HEAD INSTALLED) Remove and clean as follows: 1. Steam clean the engine. 2. Drain the fuel system. Refer to section . 3. Remove the rocker cover. Refer to section 1.2. 4. Remove the rocker arm assemblies. Refer to section 2.2. 5. Remove the intake and exhaust camshafts. Refer to section 2.2. 6. Remove the camshaft housing. Refer to section 3.1. NOTE: All valve spring or seal removal and replacement must be completed for each cylinder being serviced while the piston is at Top Dead Center (TDC). After servicing a cylinder, turn the crankshaft to TDC for the next cylinder being serviced. 7.

Remove the fuel injector from the appropriate cylinder. Refer to section . 8. Using Engine Barring Tool (J-46392), bar the engine over until the cylinder is at Top Dead Center (TDC). EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 9. Install the adaptor (J-47411) into the cylinder and torque to 20 N·m (14 lb·ft) plus 90 degrees with the injector hold-down clamp and bolt, connect shop air to compression adaptor. All information subject to change without notice. 14-22 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION