14.11 CLEANING OF VALVES AND RELATED PARTS 14.11 CLEANING OF VALVES AND RELATED PARTS Clean the valves and parts as follows: EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 1. Using proper eye protection, clean all of the disassembled parts with fuel oil and dry with compressed air. 2. Clean the carbon from the valve stems and wash the valves with fuel oil. 3. Clean the valve guide bore to remove all gum and carbon deposits use bore brush (J–5437 or equivalent) for this procedure. NOTICE:
If a valve is removed through a stem seal, the stem seal must be replaced. All information subject to change without notice. 14-26 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION