16.5 INSTALLATION OF THE CYLINDER LINER 7. Install a dial indicator. 8. Measure the distance from the top of the liner flange to the top of the block. Allowable liner protrusion is 0.18-0.27 mm (0.007-0.010 in). [a] If the liner protrusion exceeds the maximum allowable, remove the piston and connecting rod assembly (if installed) and then remove the liner to check for debris under the liner flange. [b] If the liner protrusion is below the minimum specification, contact Detroit Diesel Customer Support Center (313-592-5800). All information subject to change without notice. 16-10 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION