EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE 17.1 DESCRIPTION AND OPERATION OF CRANKSHAFT AND RELATED PARTS The crankshaft is made out of induction-hardened steel. The crankshaft bearing journals and connecting rod journals are hardened in the boundary layer and then are ground. In order to avoid vibrations, counterweights are cast onto the guide-ways. The crankshaft is mounted with seven crankshaft bearing journals in the crankcase. There are oil holes located at the crankshaft bearing journal and the connecting rod journal through which the crankshaft bearing and connecting rod bearing are lubricated. NOTE:
The DD13 engine has four counterweights, the DD15 and DD16 each have eight counterweights. NOTE: The crankshaft throws on the DD16 are longer than on the DD15 crankshaft. 1. Crankshaft Bearing Journals 3 Counterweights (number varies by engine model) 2. Connecting Rod Bearing Journals Arrows show oil passage locations Figure 17-1 Crankshaft All information subject to change without notice. DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION 17-3