Detroit Diesel DD13 DD15 DD16 — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\man81000\man81

17.4 INSTALLATION OF CRANKSHAFT 17.4 INSTALLATION OF CRANKSHAFT Install the crankshaft using the following procedure: EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 1. Steam clean the crankshaft to remove the rust preventive and blow out the oil passages with compressed air. 2. Install the upper main bearing shells in the block. If the old bearing shells are to be used again, install them in the same locations from which they were removed. NOTE:

When a new crankshaft is installed, ALL new main and connecting rod (upper and lower) bearing shells and new thrust washers must also be installed. 3. Install the thrust washer upper halves in the counterbores on either side of the No. 6 bearing saddle. Coat the backs of the thrust washers (without oil grooves) with petroleum jelly and install with the oil-grooved sides facing away from the saddle. 4. Apply clean engine oil 360 degrees around all crankshaft bearing journals and install the crankshaft. 5. Install the lower main bearing shells in the main bearing caps as follows: [a] Align the tang on the lower main bearing shell with the groove in the main bearing cap.

Install the bearing shell to the main bearing cap. NOTE: The main bearing caps are bored in position and stamped with position number. They must be installed in their original positions, with the marked (numbered) side of each cap toward the cooler side of the cylinder block. [b] If the old bearing shells are to be used again, install them in the same bearing caps from which they were removed. 6. Check main bearing cap bolt length. Table 17-2 Maximum Main Bearing Cap Bolt Length 7. Install the main bearing caps together with lower bearing shells in place. All information subject to change without notice.

17-10 DDC-SVC-MAN-0081 2010 Copyright © 2010 DETROIT DIESEL CORPORATION DD13 175.5 mm (6.909 in.) DD15 200.5 mm (7.894 in.)